Gear Pro licenses enable you to inspect spur gears, bevel gears and worms. GEAR PRO generates a CAD model of the gearing from the geometry definition. There is a graphic display allowing visual inspection of results. 

The analytical 3D gear tooth model and the graphic-supported input windows make measuring
with GEAR PRO highly effective. The software enables measurements with or without a rotary
table. Several measuring runs can be defined per measurement plan and features can be turned on
and off. An optional qs-STAT interface is available for statistical evaluation.
 

GEAR PRO involute was specially developed to
measure spur gears.
Straight or slanted-tooth spur gears
Conically corrected gears
Bevel gears
Splines

GEAR PRO bevel measures and evaluates bevel
gears. Nominal values can either be imported via
the CAD interface (Gleason, Klingelnberg,
Daimler-ZAFE, CCDS) or generated by digitizing a
master gear.

GEAR PRO worm is used to measure worms.
GEAR PRO worm takes into account the different
geometries from ZA, ZI, ZK and ZN worms.